12/30/2023 0 Comments Wayne dalton idrive customer service![]() ![]() Tighten the 3/8" square head bolt on the left hand gearĪssembly. With and rests on the teeth of the left hand gear assembly. Lift the opener slightly and slide the left hand gearĪssembly over so that the left hand drive gear meshes Opener mounting bracket over the mounting support. On doors with offsets other than 3-3/8” and 2-1/2”. IMPORTANT! This opener will not install properly ![]() Install the adjustable wall bracket to the With the header and located to allow the opener to Securely fasten a wood (2" x 6" recommended) Opener, a strong mounting support will be needed. If there are no suitable mounting surfaces to mount the See the illustration below for the dimensions required for the Torsion idrive™ Garage Door Opener. Maximum door weight must not exceed 400 lb. Your Garage Door must be properly balanced (door must not be heavy to lift, nor lift by itself). Torsion idrive™ will only work on multi-sectional doors. Required distance from the center of the torsion tube to the header (mounting location) must be 2-1/2" to There must be at least 7.5" of clearance between the top of the door and the center of the torsion tube. The motor requires between 3-1/4" to 5" of headroom above the center of the torsion tube. When installing idrive, ensure there is at least 6" of clearance between the “S” hook and the disconnect cable guide bracket. There must be at least 30-3/8" of clear torsion tube between the right (inside garage looking out) cable drum and the counterbalance spring. Follow theĬAUTION DO NOT INSTALLTHIS OPENER ON YOUR DOOR UNLESS THE FOLLOWING ITEMS ARE MET. WARNING: Changes or modifications to this unit not expressly approved by party responsible for compliance could void user’s authority to operate this equipment.īefore installing Torsion idrive™, ensure your door system meets the following requirements. Consult your dealer or/and experienced radio/television technician for help. Connect equipment into an outlet on a circuit different from that which receiver is connected. ![]() Increase separation between equipment and receiver. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning equipment off and on, user is encouraged to try to correct interference by one or more of the following measures: Reorient or relocate receiving antenna. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with these instructions, may cause harmful interference to radio communication however, there is no guarantee that interference will not occur in a particular installation. These limits are designed to provide reasonable protection against harmful interference in a residential installation. NOTE: This equipment has been tested and found to comply with limits for a Class B digital device, pursuant to Part 15 of FCC Rules. (2) this device must accept any interference, including interference that may cause undesired operation of the device. Operation is subject to the following two conditions: (1) this device may not cause interference, and Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device complies with Part 15 of the FCC Rules. Perform monthly maintenance (see Maintenance section page 30) and periodic checks, as recommended. ![]() After installation is complete, fasten this manual near garage door. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |